Designing – Chimney stove

The chimney stove does not need a plinth, or brickwork. Because it is delivered already in a ready-to-install condition, we only need to make a connection to the chimney and remember to comply with fire regulations. For chimney stove, as for all other tiled stoves, the required lateral spacing must be maintained, from above and around the hearth. In terms of the shape of the external surface, we are basically dependent on the offers of manufacturers. Thanks to their great variety and the possibility of taking a chimney stove with you during the subsequent move and easy installation in a new place, it is a good alternative to a tiled stove. When the stove is far away from the chimney connection, Check, whether the vacuum in the chimney is sufficient. If other combustion chambers are connected to this chimney, only a chimney stove of the type can be used 1 by DIN 18891 (markings for horizontal projection: 1 = visible outer surface of the chimney, 2 = combustion chamber, 3 = glass doors, 4 = flue gas pipe, 5 = floor plate).

Materials used in electrical engineering Materials used in electrical engineering. Electrotechnical products are manufactured from a wide variety of materials, which, due to their functional properties, have been divided into ... under Electrician
Chimney for a tiled stove The tiled stove is very nice, a pleasant and romantic source of warmth. Usually it is fired with wood, which is self-renewing ... under Architecture
Intermediate foundations – piles and wells Direct foundation of the building takes place then, when the load is transferred to the bearing layer of the soil, located directly under the foundation. If the layer ... under Architecture
Combined tiled stove Combined stove - In terms of the principle of operation and construction, a combined tiled stove is largely similar to a convection tiled stove ... under Heating
The furnace of prof. Adamiecki The furnace of prof. Adamiecki. In years 30 In the twentieth century, professor of the Warsaw University of Technology, Eng. Adamiecki designed a ductless residential furnace with great efficiency ... under Heating
Bricks for the construction of furnaces For the construction of stoves and kitchen cabinets with skillful work, you can use approx 50% ordinary brick. It is best to use a hand brick ... under Heating
Covering wooden roofs of single-family houses with a corrugated sheet Roofs covered with sheet metal are exposed to unfavorable phenomena consisting in settling of moisture on the underside of the sheets, condensation of water vapor, rafting ... under Architecture
Energy storage for latent and chemical heat Latent heat stores use physical properties, i.e.. high heat and low melting point of some compounds. Cartridges containing salt solutions ... under Architecture
Stove fitting tools Stove fitting tools: a) the stove fitting, b) tile cutter, c) Small stove-fitting hammer, d) Big blowout hammer, e) punch ... under Heating
Tasks and division of foundations The task of the foundation is to transfer the weight of the building and all loads acting on the building onto the ground (the burden of people, equipment, snow loads and ... under Architecture