Capacitive electric furnaces

Electric underfloor heating.

Capacitive electric furnaces. Electricity is used for occasional heating with sheet metal, capacityless stoves and for the most hygienic floor and ceiling heating.

Recently, there has been an effort to use electric current to heat storage heaters as well.

The figure shows a portable electric furnace with medium heat capacity, the structure of the author of the book. This oven has dimensions 1,5 X2.5X3 tiles have 8 chamotte channels for heating elements, 8 channels for heat dissipation through the heated wall of the channel through the openings to the outside. With its external surface, the stove transfers heat to the room through radiation and convection, the inner walls of the channels dissipate heat through 8 circulation channels with increased convection with blowing, because every channel has 2 holes, (down and up).

The heating surface of this furnace, totals 2,5 m2. The furnace can be wheeled for easy transport.
Heating with electric stoves has many advantages over gas, like a simple structure, low installation cost, no combustion process, unnecessary chimneys for the discharge of combustion products, non-polluting the air in the premises, safety and ease of use and operation.
Only the high cost of electricity limits the use of electricity on a larger scale for heating homes. However, in many countries there are efforts to reduce the cost of electricity.

Materials used in electrical engineering Materials used in electrical engineering. Electrotechnical products are manufactured from a wide variety of materials, which, due to their functional properties, have been divided into ... under Electrician
Chimney for a tiled stove The tiled stove is very nice, a pleasant and romantic source of warmth. Usually it is fired with wood, which is self-renewing ... under Architecture
Intermediate foundations – piles and wells Direct foundation of the building takes place then, when the load is transferred to the bearing layer of the soil, located directly under the foundation. If the layer ... under Architecture
Combined tiled stove Combined stove - In terms of the principle of operation and construction, a combined tiled stove is largely similar to a convection tiled stove ... under Heating
The furnace of prof. Adamiecki The furnace of prof. Adamiecki. In years 30 In the twentieth century, professor of the Warsaw University of Technology, Eng. Adamiecki designed a ductless residential furnace with great efficiency ... under Heating
Bricks for the construction of furnaces For the construction of stoves and kitchen cabinets with skillful work, you can use approx 50% ordinary brick. It is best to use a hand brick ... under Heating
Covering wooden roofs of single-family houses with a corrugated sheet Roofs covered with sheet metal are exposed to unfavorable phenomena consisting in settling of moisture on the underside of the sheets, condensation of water vapor, rafting ... under Architecture
Energy storage for latent and chemical heat Latent heat stores use physical properties, i.e.. high heat and low melting point of some compounds. Cartridges containing salt solutions ... under Architecture
Stove fitting tools Stove fitting tools: a) the stove fitting, b) tile cutter, c) Small stove-fitting hammer, d) Big blowout hammer, e) punch ... under Heating
Tasks and division of foundations The task of the foundation is to transfer the weight of the building and all loads acting on the building onto the ground (the burden of people, equipment, snow loads and ... under Architecture