PIECE BEZPOJEMNOŚCIOWE

PIECE BEZPOJEMNOŚCIOWE

In addition to heat-storing furnaces, non-capacitive furnaces are also used, that is, they do not accumulate heat and cool down quickly after smoking is stopped. Depending on the type of fuel used, these furnaces are divided into:

a) non-capillary coal furnaces,

b) non-capillary petroleum furnaces,

c) noncapacity gas furnaces,

d). electric non-capillary furnaces.

Non-capacitive coal furnaces. Coal-fired furnaces are mostly portable, can be divided into ordinary iron furnaces without or. with chamotte carpet, and for continuous burning furnaces,

The simplest type of lined iron furnace, for continuous smoking.

The simplest type of lined iron stove for continuous burning is shown in the figure. The furnace consists of a charging shaft, outer sheath, fireclay flooring, grate, the door with- checkered, charging door and a smoke pipe with a throttle. The ash door with a regulating latch is used to regulate the air supply.

An important feature of a continuous burning stove is a basket grate, located above the usual shaking grate and a hopper extending from the furnace head almost to the grate. The hopper is used as a fuel tank here, which, as the fuel burns in the basket grate, slides into it from the hopper.

An American continuous burning oven.

Materials used in electrical engineering Materials used in electrical engineering. Electrotechnical products are manufactured from a wide variety of materials, which, due to their functional properties, have been divided into ... under Electrician
Chimney for a tiled stove The tiled stove is very nice, a pleasant and romantic source of warmth. Usually it is fired with wood, which is self-renewing ... under Architecture
Intermediate foundations – piles and wells Direct foundation of the building takes place then, when the load is transferred to the bearing layer of the soil, located directly under the foundation. If the layer ... under Architecture
Combined tiled stove Combined stove - In terms of the principle of operation and construction, a combined tiled stove is largely similar to a convection tiled stove ... under Heating
The furnace of prof. Adamiecki The furnace of prof. Adamiecki. In years 30 In the twentieth century, professor of the Warsaw University of Technology, Eng. Adamiecki designed a ductless residential furnace with great efficiency ... under Heating
Bricks for the construction of furnaces For the construction of stoves and kitchen cabinets with skillful work, you can use approx 50% ordinary brick. It is best to use a hand brick ... under Heating
Covering wooden roofs of single-family houses with a corrugated sheet Roofs covered with sheet metal are exposed to unfavorable phenomena consisting in settling of moisture on the underside of the sheets, condensation of water vapor, rafting ... under Architecture
Energy storage for latent and chemical heat Latent heat stores use physical properties, i.e.. high heat and low melting point of some compounds. Cartridges containing salt solutions ... under Architecture
Stove fitting tools Stove fitting tools: a) the stove fitting, b) tile cutter, c) Small stove-fitting hammer, d) Big blowout hammer, e) punch ... under Heating
Tasks and division of foundations The task of the foundation is to transfer the weight of the building and all loads acting on the building onto the ground (the burden of people, equipment, snow loads and ... under Architecture